research papers on marble aggregate concrete
Home > Products > research papers on marble aggregate concrete

research papers on marble aggregate concrete

Waste Marble Chips As Concrete Aggregate

2016-7-18 · marble is well usable instead of the usual aggregate in the concrete paving block production[10]. Use of waste marble in concrete as aggregate can save about 5% and 4 % the cost of concrete per meter cube with O.P.C and P.P.C respectively, thus it can be say

Read More

Utilization of “Marble Slurry In Cement Concrete

2015-1-15 · properties of concrete”Scientific Research and Essay Vol. 2 (9), pp. 372-379, (2007). [6] H. Βinici, H kaplan. And S. Yilmaz „Influence of marble and limestone dusts as additives on some mechanical properties of concrete‟, Scientific Research and Essay, Vol.2 (9), 372-379, Full Length Research Paper (2007).

Read More

Analysis on Mix Design of High Strength Concrete (HSC ...

2017-6-19 · International Journal of Scientific and Research Publications, Volume 7, Issue 6, June 2017 596 ISSN 2250-3153 Analysis on Mix Design of High Strength Concrete (HSC) using IS: 10262-1982 and partial replacement of waste marble aggregates as coarse aggregate Debasmita Panda*, Dr.

Read More

Marble Powder As Fine Aggregates in Concrete |

Marble industry contributes significantly to the socio-economic development of any country. Due to the abundance of marble reserves, Pakistan relies on marble industry, which in turn contributes to its GDP. Marble powder (MP), produced from the marble industry is also increasing, which constantly remains a source of hazards to the environment.

Read More

Concrete Research Papers - Academia.edu

Designing concrete based on aggregate packing and optimized gradations can result in 25 % less cement content to reach a targeted compressive strength and less water-reducing admixture to obtain a required consistency. In this research, two studies were conducted: (1) an experimental analysis to determine the effects of aggregate packing on ...

Read More

A brief review on sustainable utilisation of marble waste ...

A brief review on sustainable utilisation of marble waste in concrete Sudarshan D. Korea, A. K. Vyasb and Syed Ahmed Kabeer K.I. c aSchool of Construction Management, National Institute of ...

Read More

(PDF) Use of recycled concrete aggregate in concrete:

The use of recycled concrete aggregate (RCA) in concrete as partial and full replacements of natural coarse aggregate is growing interest in the construction industry, as it reduces the demand for ...

Read More

[PDF] Effect of Coarse Aggregate Size on the

2021-3-5 · Concrete structures deflect, crack, and loose stiffness when subjected to external load. Loss of flexural strength of concrete is largely responsible for cracks in structure. In reinforced concrete structures, the mix proportions of the materials of the concrete and aggregate type determine the compressive strength while the composite action of concrete and steel reinforcement supplies the ...

Read More

Lightweight Aggregate Concrete Research Papers -

View Lightweight Aggregate Concrete Research Papers on Academia.edu for free.

Read More

Partial Replacement of Cement With Marble Powder

The coarse aggregate fine angular sharpened edges aggregates were available from local sources. Water: Potable water used for mixing and curing purposes. Preparing of concrete and for this purpose used in the Water cement ratio is W/C of 0.52 (52%) water range 6 to 7.5PPM. Marble powder: The marble

Read More

(PDF) Marble replacing fine aggregates - Share research

TABLE 8 COMPRESSIVE STRENGTH OF CONCRETE WITH VARYING PERCENTAGE OF MARBLE WASTE Compressive strength % Marble 7 day 14 day 28 day 0 31 33 38 5 31.5 34 39 10 33 34.5 40 15 33 35 40.5 20 33.5 35.5 39 REFERENCES [1] A K Mishra, Renu mathur, Y V Rao, A P Singh and Pankaj Goel, “A new technology of marble slurry waste utilization in roads ...

Read More

Experimental Study On Concrete Using Waste Marble

2018-7-5 · of using marble powder waste as partial replacement of fine aggregate in concrete. Since this concrete is prepared with marble powder as a partial replacement of fine aggregate (Sand) in four different proportions i.e. 10%, 15 % ,20% and 25 % and tested for the period of

Read More

Review Paper on Partial Replacement of Concrete

2015-1-6 · concrete by using tests like compression strength. Candra Aditya et al. [6] researched on alternative materials primarily from waste have been additional material at area manufacture of building materials, especially concrete roof tile. Their research would expand utilization of marble waste in East

Read More

Comparing the Effect of Marble Powder and Brick Powder

2019-2-18 · The research work carried out included an experimental investigation on strength properties of concrete made with 30% ,35%, 40%of marble fines and same percentage brick dust replace the cement of less than 90 micron particle size. The experimental work was carried o of river sand as fine aggregate in concrete.

Read More

Effect of marble waste aggregate percentage with fly

Pervious concrete with marble and gravel substitution shows low compressive strength. In another attempt the experiments carried out by adding fly ash as much as 20% of the weight of cement showed an optimal strength. This research aims to increase the compressive strength of pervious concrete by modify coarse aggregate proportions and adding fly ash admixture.

Read More

[PDF] Characterization of marble powder for its use in ...

2021-1-22 · Abstract A powder obtained as a by-product of marble sawing and shaping was characterized from a chemical and physical point of view in order to use it as mineral addition for mortars and concretes, especially for self-compacting concrete. This marble powder showed a very high Blaine fineness value of about 1500 m2/kg, with 90% of particles finer than 50 μm and 50% under 7 μm.

Read More

[PDF] Effect of Expanded Perlite Aggregate Dosage on ...

2021-3-2 · In this paper, an experimental study was carried out in order to provide more data on the effects of expanded perlite aggregate (EPA) dosage on the compressive strength and thermophysical properties of lightweight concrete at different ages. The first part of this experimental study was devoted to the choice of the proper mixing procedure for expanded perlite concrete (EPC).

Read More

Partial Replacement of Cement With Marble Powder

The coarse aggregate fine angular sharpened edges aggregates were available from local sources. Water: Potable water used for mixing and curing purposes. Preparing of concrete and for this purpose used in the Water cement ratio is W/C of 0.52 (52%) water range 6 to 7.5PPM. Marble powder: The marble dust is obtained from RAK ceramics.

Read More

Review Paper on Partial Replacement of Fine Aggregate

2018-4-20 · Therefore this paper presents the review of some research papers which uses locally available waste replacing fine aggregate. Research in this field and positive results of their research work are important to study further in the sustainable construction activities by

Read More

Mechanical Properties of Steel Fiber -Waste Marble ...

In this research, the enhancement of compressive, tensile and flexural strength of concrete mixtures was explored using both waste white marble instead of aggregate and steel fibers. White marble was mixed with an ordinary Portland cement replacing the mixture of both coarse and fine aggregate by 10%, 50% and 100% of weight. Besides adding the steel fibres to mixture with a total volume of ...

Read More

Comparing the Effect of Marble Powder and Brick Powder

2019-2-18 · The research work carried out included an experimental investigation on strength properties of concrete made with 30% ,35%, 40%of marble fines and same percentage brick dust replace the cement of less than 90 micron particle size. The experimental work was carried o of river sand as fine aggregate in concrete.

Read More

EXPERIMENTAL STUDY ON PARTIAL REPLACEMENT OF

2018-11-5 · The following tests were conducted on conventional concrete and concrete with partially replaced seashell as coarse aggregate of different percentages and partially replaced cement for fly ash with constant percentage. These tests are carries out as per IS: 516-1959. i. Compressive strength test ii. Split Tensile strength test iii.

Read More

THE NEED FOR STANDARDIZATION OF AGGREGATES

2009-10-7 · the aggregate particles has to be obtained from indirect tests, such as crushing strength of prepared rock samples, crushing value of bulk aggregate, and performance of aggregate in concrete. The aggregate crushing value (ACV) test is prescribed by different standards, and is a useful guide when dea1ing with aggregates of unknown performance.

Read More

Effect of marble waste aggregate percentage with fly

Pervious concrete with marble and gravel substitution shows low compressive strength. In another attempt the experiments carried out by adding fly ash as much as 20% of the weight of cement showed an optimal strength. This research aims to increase the compressive strength of pervious concrete by modify coarse aggregate proportions and adding fly ash admixture.

Read More

252 Review Paper on Properties of Concrete Partial ...

2018-10-30 · replacement of c ement and concrete production. In this research we analyze the strength of concrete made with using these waste materials one is Fly ash and other is Stone dust. The Fly as his used as 20% replace by weight of cement and Stone Dust as the partial replaceme nt of Fine Aggregate from 0%, 10%, 20%, 30% and 40%.

Read More

Recycled aggregate as structural material

2016-2-9 · This research examines whether the use of RA in concrete production is appropriate. The utilization ... Keywords C&D waste Recycled aggregate Concrete Geometrical–physical properties Introduction ... ent material including pieces of concrete, bricks, ceramic tiles, marble, asphalt etc. Materials and Methods

Read More

Advanced Technology in Concrete Technology

Concrete is a composite material composed of water, coarse granular material embedded in a hard matrix of material (the cement or binder) that fills the space among the aggregate particles and glues them together. In addition, the marble cutting industry generates a high volume of wastes.

Read More

Mechanical Properties of Steel Fiber -Waste Marble ...

In this research, the enhancement of compressive, tensile and flexural strength of concrete mixtures was explored using both waste white marble instead of aggregate and steel fibers. White marble was mixed with an ordinary Portland cement replacing the mixture of both coarse and fine aggregate by 10%, 50% and 100% of weight. Besides adding the steel fibres to mixture with a total volume of ...

Read More

farhathullah reuse & recycle GSDassignment.pdf -

The research paper suggests using of marble dust to replace concrete with 10% can improvise concrete’s compressive strength & improve water retaining capacity. Using broken marble stones, which are bigger than fine particles can be used in aggregates & works well too. Fine particles of marble can be used in replacing 15% of Portland cement in mortar to increase its workability.

Read More

Concrete Engineering - Page 3

The test results show that the compressive strength, split-tensile strength and flexural strengths are achieved up to 30% to 40% replacement of cement with marble powder without affecting the characteristic strength of M20(1:1.5:3) grade concrete. KEYWORDS: Cement (53 grade), Marble powder, Fine aggregate (M-sand), Coarse aggregate (20mm size).

Read More